Machining the Drill Bit to fit in the Drill - Laurie Bridger (Laurie) Viewed: 1686 times.
|
| Loctite's misleading packaging. If you're looking for 'RED Loctite' - don't be fooled by the box! JKS specifies 271, which is red and very strong. 243 is a bit weaker but will have to do as it's all we can find. - Laurie Bridger (Laurie) Viewed: 1681 times.
|
| Enlarging the hole in the chassis attachment point to 9/16 inch. - Laurie Bridger (Laurie) Viewed: 1619 times.
|
|
Frame End attached, axle end temporarily supported by masking tape for a third hand. - Laurie Bridger (Laurie) Viewed: 1669 times.
|
| Axle end needs special nut to use original hole (left). Red arrows show where it was not possible to get a wrench to fit. This special nut was discarded when they used the re-drilled hole, which can be accessed, shown by the green arrow. - Laurie Bridger (Laurie) Viewed: 1803 times.
|
| Collar in my swaybar fitted when the Skyjacker disconnects were removed. Skyjacker requires enlarging the hole. This collar worked for the Teraflex ones but is too tight to be used with JKS, so we need to enlarge this too, although this is not something you're likely to encounter. - Laurie Bridger (Laurie) Viewed: 1747 times.
|
|